Design of a New Washing Machine to Clean the Needle Bed of an Electronic Flat Knitting Machine: WASHING MACHINE FOR CLEANING NEEDLE BEDS

Nevin Celik; Irfan Yolcular; Songul Kasap; Mehmet Burak Golen; Ali Taskiran

doi:10.56042/jsir.v84i1.8727

Authors

Nevin Celik Department of Mechanical Engineering, Firat University, 23119, Elazig Turkiye
Irfan Yolcular R & D Department of NIT ORME Co., 34035, Bayrampasa, Istanbul, Turkiye
Songul Kasap R & D Department of NIT ORME Co., 34035, Bayrampasa, Istanbul, Turkiye
Mehmet B Golen R & D Department of NIT ORME Co., 34035, Bayrampasa, Istanbul, Turkiye
Ali Taskiran Department of Mechanical Engineering, Firat University, 23119, Elazig Turkiye

DOI:

https://doi.org/10.56042/jsir.v84i1.8727

Keywords:

Design and prototype, Electronic flat knitting machine, Manufacturing, Needle bed washing, Optimization

Abstract

An electronic flat knitting machine is traditionally used for knitting pullovers and other outerwear garments. When a typical electronic flat knitting machine runs for a certain time, the needle bed is filled with dust and lubrication. In order to solve this problem, a new needle bed cleaning machine is designed and manufactured by R&D department of “NIT ORME” Co. located in Turkey. In this article, the introduction of the washing machine, of which the prototype is produced and patented, and some analyzes, such as; structural, fluid flow and vibration, performed during the design of the machine is presented. SoloidWorks, ANSYS-Structural and ANSYS-CFX are the commercial softwares used for the analyses. As a result of the prototype production, the needle bed of knitting machines is automatically washed and dried faster than similar products in a practical, easier and functional way. Additionally, the cleaning costs are reduced by 70% with the washing machine.